HLCALUMINUMaluminum composite panels manufacturers
Author?: HLCALUMINUM?–?Aluminum Composite Panels Manufacturers & Suppliers
There are many places that use products such as hyperbolic aluminum veneers for styling. Products such as hyperbolic aluminum veneers are still very good. It will be more cost-effective for users to choose to use such products. If you want To produce good hyperbolic aluminum veneers, the requirements for the production process are relatively high. Below we will introduce the production process requirements of hyperbolic aluminum veneer in two aspects. 1. Material requirements: 1. The aluminum plate used should meet the requirements of GB/T3880, and 3003H24 or 1100H24 aluminum plate should be selected.
2. Aluminum veneer substrate thickness: 2.0 0.10mm 2.5 0.15mm 3.0 0.25mm. 3. The allowable deviation of the main surface dimensions of aluminum veneer forming parts: 0.5MM. 2. Quality of surface spraying: 1. Thickness of surface coating: The film layer of surface spraying layer should not be less than 33 m, and the film thickness of spraying layer should not be less than 50 m.
2. There should be no obvious color difference on the surface. 3. The coating on the decorative surface should be complete, and no obvious damage, peeling and other defects are allowed. 4. The adhesion of the coating on the decorative surface should not be lower than level 2.
5. The coating should have no obvious discoloration and peeling off after the salt spray test. 6. The moisture and heat resistance of the surface coating should reach the first grade. If you want to make a good hyperbolic aluminum veneer, then its process requirements are very important. If the standard is not met during the production process, then the quality of the produced hyperbolic aluminum veneer may not pass the standard.
For hyperbolic aluminum veneer manufacturers, they pay more attention to these when producing such products. Hyperbolic aluminum veneer,.