Aluminium Composite Panel Manufacturers & Suppliers in China since 2002 - Henglicai ACP
Language
Aluminium Composite Panel Manufacturers & Suppliers in China since 2002 - Henglicai ACP
There are actually many functions of aluminum-plastic panels. This kind of product is often used in home decoration, especially in the ceiling, but what aspects do you need to pay attention to in the ceiling? ?Here is a brief introduction to the relevant knowledge points for everyone.
1. Do not tear off the protective film of the aluminum plate
For the new aluminum ceiling, there is a layer of protective film on its surface, so before installation, we first need to calculate the installation area of the aluminum ceiling and how much film will be torn off.
The rest of the aluminum ceiling that does not break the film can be returned, so you must pay attention to this.
Don't tear off all the aluminum ceiling film at one time, then you can't get it back, you have to pay for it yourself.
2. The film of the aluminum plate ceiling must be torn off before installation
In some houses, the homeowners did not take lessons during the decoration process, and did not tear off the film before installing the aluminum plate ceiling, but after installation, they remembered to tear off the film evenly, but at this time the film is not easy to tear off, often There will be some residue, and if the force is too large, it will also cause the deformation of the aluminum ceiling.
3. Make a mark on the water circuit
Because this will involve a stamping process, the walls will have to be marked after the waterways and waterways have been completed.
In this way, we can avoid these places when punching holes, otherwise, when the time comes, once a hole is punched for electrical wires and water pipes, it will be troublesome later.
4. The problem of hollow tiles must be avoided
It's still about drilling. If the tiles on the wall are hollow, it is easy to chip the tiles later in the drilling process.
Therefore, before making the aluminum ceiling, it is necessary to do a good job in the acceptance of ceramic tiles.
5. Punching depth
The drilling depth is 3-4 cm. In addition to avoiding hitting the pipe, it is also important to avoid damaging the waterproofing.
Therefore, the depth of the drilled hole should not be too deep (3-4 cm).
6. Plan lighting vent locations ahead of time
To avoid trouble in the future, before installing the aluminum plate ceiling, we must design the installation position of the lighting vent and the kitchen radiator.
After this introduction, everyone should understand and understand! If you have any understanding of this kind of products, pay attention to us.
