Aluminium Composite Panel Manufacturers & Suppliers in China since 2002 - Henglicai ACP
Language
Aluminium Composite Panel Manufacturers & Suppliers in China since 2002 - Henglicai ACP
Hlcaluminium -
The premise of folding the aluminum composite panel is that the aluminum foil is thick enough, the thicker the aluminum skin, the better the folding. The groove comes out, otherwise it will not be able to fold. The depth of the slot is adjusted according to the thickness of the aluminum plastic. First, shorten the cutter head and try it slowly until the aluminum skin does not seem to be exposed. If it is too deep, it is easy to scratch the aluminum skin and cause the folded edge to break. If it is too shallow, it is not easy to fold the edge and it is easy to burst.
The other is to use the cutter head. There are two kinds of cutter heads, U-shaped (commonly called round to head) and V-shaped (commonly called sharp cutter head). The U-shaped cutter head is not easy to scratch the aluminum skin, but the folded corner is not It is very straight. If the V-shaped cutter head is more pointed, the folded angle is very straight. The angle is better, but it is easy to scratch the aluminum skin and cause the aluminum skin to crack. Generally, a 6# cutter head can be used for a 4 mm aluminum composite panel.
The folding of the aluminum composite panel mainly depends on the aluminum skin. The misunderstanding of many people is that raw rubber cannot be folded, but cooked rubber can be folded.
In fact, this is wrong, because the middle plastic is to be removed in the folding, so the folding mainly depends on the thickness of the aluminum skin. Under normal circumstances, more than 8 wires that are often sold in the market fully meet the needs of 90-degree right-angle hemming.
