HLCALUMINUMaluminum composite panels manufacturers
Author?: HLCALUMINUM?–?Aluminum Composite Panels Manufacturers & Suppliers
In some large cities in China, the shadow of double-curved aluminum veneer curtain wall can often be seen. The overall decoration effect of the building it brings is very good, leaving an unforgettable deep impression on people. However, some professionals in the industry have found that the overall effect of the double-curved aluminum veneer curtain wall is not as good as expected. For example, the entire wall is uneven, there are creases on the reflective part, and the board surface is uneven.
So, what causes the actual effect of the double-curved aluminum veneer curtain wall is not good? The reasons for the poor effect of the double-curved aluminum veneer curtain wall may be directly related to the following points. First of all, there may be problems with the installation, including the adjustment of the system considering the installation and the quality of the on-site installation. The second is that the aluminum plate is too thin or the arrangement of the ribs is not reasonable enough, the structural performance of the aluminum plate itself and the environmental protection and aesthetic performance are insufficient; or the support system is insufficient, the adjustment of the horizontal and vertical frames, the error of the main structure and the problems during the construction process.
Thirdly, the technical problem of the hyperbolic aluminum veneer curtain wall may be that the deformation of the stressed part is too obvious, and the thinner aluminum plate will also lead to poor actual production effect. Aluminum veneer manufacturers said that if they want to do well, they can only splice horizontal blocks. Each board is an independent and non-interchangeable forming surface. After the board is formed, it is fixed with a unified and interchangeable rear bracket. The size is fixed and matched with the wall keel. It is packaged during transportation and handled properly so that it will not deform. When installing, the bracket should not touch the molding surface after installation. If the molding surface is not stressed, it will not deform. It is best to stick a film on the front. The overall installation is complete After that, it is packed from top to bottom. Hyperbolic aluminum veneer,.