Aluminium Composite Panel Manufacturers & Suppliers in China since 2002 - Henglicai ACP
Language
Aluminium Composite Panel Manufacturers & Suppliers in China since 2002 - Henglicai ACP
HLCALUMINUM
Author?: HLCALUMINUM?–?
Hyperbolic aluminum veneer curtain wall, the overall shape is petal shape, made of 2.5 thick aluminum veneer. The board is a big and small head. After dismantling, the effect is not very good.
The entire wall surface is uneven and there are obvious creases on the reflective surface. There will always be a feeling of imbalance. Today I will help you analyze the reasons and how to do a similar project. 1. Possible installation problems, including installation system adjustment and on-site installation quality.
2. The first aluminum plate is too thin or the ribs are unreasonably arranged, resulting in insufficient structural performance and environmental friendliness of the aluminum plate itself. Insufficient second support system, adjustment of horizontal and vertical frame, error of main structure and third problem during construction, these are all kinds of problems. The fourth one deals with issues. The third and fourth ones have a lot to do with the company.
The problem with the fifth part of the connection usually exists in this link. I have done a lot of double-curved buildings, stainless steel panels, double-curved aluminum veneers, metal roof glass, etc. From my point of view, your effect has been very good.
3. One is rational division, and the other is the production level of aluminum plate deep processing units. 4. Process problems, the deformation of the stressed part is too obvious, and the aluminum plate is very thin. If you want to do well, you can only splice modules.
Each plate is an independent and non-interchangeable molding surface. After the sheet is formed, it is secured with uniform interchangeable rear supports. The size of the rear bracket is fixed, the wall keel is matched, and it is packed well during transportation without deformation.
When installed, the bracket should not touch the front molding surface, and the plastic surface will not be affected. Will not deform. Preferably glued to the film on the front.
The entire installation is complete, and the packaging is from top to bottom. I'm not doing aluminum finishes, but I don't think there would be a problem if I did. Wall mounting will cause distortion.
You are fixed on the bracket in front of the wall, the deformation range. It can be controlled to a minimum, after all it is more precise in the factory than in the field. Of course, this will increase the cost of installation, rear bracket module, shipping and packaging.
But it's worth every penny. Not that it's bad, or that money wasted. 6. Possible installation problems, including system precautions for installation and adjustment, on-site installation quality, possible installation problems, system installation and adjustment precautions, and on-site installation quality control.
7. It is a flat plate. One of the reasons is probably that the bending of the flat plate is not uniform. 8. There is a reason for this. The hyperboloid of this manual installation operation, the effect of assembling one board and one board is unavoidable.
After all, drawing on a computer is no good. First of all, the double song you mentioned is just a double song. But in fact, the aluminum plate you use is a flat plate, so your aluminum plate is not hyperbolic, that is, the flat plates are assembled into a hyperbolic shape.
This effect can be thought of by yourself. If the radius of the hyperbola is large enough, the arc length and chord length of the individual plates are the same (ie, they are basically close), so the assembly works better. Otherwise, it is better to use hyperbolic processing for individual plates.
Then when processing the hyperbolic aluminum veneer, the arrangement of the ribs, the deformation control of the processing, especially the edge position. Then control the color, variance, etc. of the aluminum surface layer. Hyperbolic aluminum veneer,.
